Water Jet Cutting and Abrasive Jet Nozzles
For pressure up to 60,000 PSI
KMT
KMT
Type : 10 Series
Download PDF
KMT Autoline
Type : 27 Series
Download PDF
Flow Systems
Type : 18 Series
Download PDF
Flow Systems Paser III
Type : 32 Series
Download PDF
Flow Systems Low Mass
Type : 25 Series
Download PDF
Focusing Nozzles – KMT
| Extra Long Life Focusing Nozzles (mixing tubes) to suit KMT, Flow Systems, Allfi, Jet Edge Abrasive Cutting Heads | |||
| Outside Diameter | Length | Inside Diameter | |
| 9.4mm | 76mm | 0.76mm | |
| 9.4mm | 76mm | 1.00 mm | |
Focusing Nozzles – Flow Systems
| Flow Systems | |||
| Outside Diameter | Length | Inside Diameter | |
| 7.1mm | 76mm | 0.76mm | |
| 7.1mm | 76mm | 1.00mm |
Focusing Nozzles – Allfi, Jet Edge
| Outside Diameter | Length | Inside Diameter | |
| 6.3mm | 76mm | 0.76mm | |
| 6.3mm | 76mm | 1.00mm | |
| Other sizes available on request. | |||
Integral Diamond Eductor
The H20 Jet Integral Diamond Eductor provides a fast, accurate cut due to the precise alignment of the orifice with the mixing tube which in turn can reduce garnet consumption and increase carbide life.
Spare Parts
High pressure seal kits, check valve repair kits, standard or high load piston and plunger assemblies are all available. You can also obtain all your flow systems compatible spare parts. Contact us with your part number and description of the part you are looking for.
Blue Goop
Thread lubricant used to eliminate galling on any material fortemperatures up to 204°c.
Intensifier Assembly
- Mechanical Shift or Electronic Shift
- Hi load
- Rated to 40,000 psi or 60,000 psi
Intensifier short blocks also available
Contact us for a H2O
Jet catalogue on CD
Intensifier Pumps
The H2O Jet intensifier pump maintains the maximum pressure and flow while virtually eliminating pressure fluctuations. With a simple and straightforward design you can improve the quality of your cuts at a much faster speed.
- Maximum Flow Rate – 10.3 l/m
- Maximum Pressure – 60,000 PSI
- Maximum Orifice Size – 0.025″
- 50 or 100 HP
